Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Chevrolet Astro Van Cargo, RWDFACTORY OEM SERVICE PROCEDURE
Setup New Body Control Module
WARNING: This page is about a different car, the 2001 GMC Safari and 2001 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Body Control Module (BCM) will not function properly if setup new BCM procedure is not performed. Perform theft deterrent re-learn procedure after successfully finishing setup new BCM procedure. If theft deterrent re-learn procedure is not performed after BCM replacement, following conditions may occur: Vehicle will not be protected against theft by PASSLOCK system. Engine will not crank or start.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.