2002 Chevrolet Astro Van Cargo, AWDFACTORY OEM SERVICE PROCEDURE

Diagnostic Aids

WARNING: This page is about a different car, the 2001 GMC Safari and 2001 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.

If CKP learn procedure cannot be learned, check for a chipped or damaged reluctor wheel, incorrect CKP sensor alignment to reluctor wheel, excessive crankshaft runout, interference in signal circuit to CKP sensor or incorrect ratio of crankshaft to camshaft pulses.

If PCM receives an incorrect crankshaft to camshaft ratio, PCM will not allow scan tool to enable learn procedure.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.