2002 Chevrolet Astro Van Cargo, AWDFACTORY OEM SERVICE PROCEDURE

Component Locations

WARNING: This page is about a different car, the 2001 GMC Safari and 2001 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
COMPONENT LOCATIONS

Component Location
Ambient Light Sensor Top Of Instrument Panel, In Left Side Speaker Grille
Transfer Case Shift Control Module (ATC/TCSCM) Left Kick Panel
Body Control Module (BCM) In Instrument Panel, Above Radio
Data Link Connector (DLC) Under Left End Of Instrument Panel
Door Ajar Switch In Respective Door
Electronic Brake Control Module (EBCM) On Frame, To Left Of Transmission
Ignition Switch In Steering Column
Relay Block Under Left End Of Instrument Panel, Above DLC
Instrument Panel Fuse Block Under Left End Of Instrument Panel
Parking Brake Switch Connector Under Left Kick Panel
Powertrain Control Module (PCM) Left Side Of Engine Compartment, Under Battery
Seat Belt Switch Under Driver's Seat
Sensing & Diagnostic Module (SDM) Under Driver's Seat
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.