SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001VENTURE BASE, VAN CARGO EXTENDEDREPAIR AND DIAGNOSISGENERAL INFORMATIONCOMPUTER RELEARN PROCEDURESGENERAL MOTORS (CARS)CAMARO & FIREBIRDPROGRAMMING NEW BODY CONTROL MODULE (BCM)
2001 Chevrolet Venture Base, Van Cargo Extended

Programming New Body Control Module (BCM)

2001 Chevrolet Venture Base, Van Cargo ExtendedSECTION Programming New Body Control Module (BCM)
NOTE: New modules are unprogrammed. New module must be programmed with code that matches customer's key for PASS-Key® II operation. New module can only be programmed once.
  1. To program a NEW Body Control Module (BCM), install new module into vehicle. Insert customer's key into ignition lock cylinder and turn to RUN position. Start engine to verify operation.
  2. Observe SECURITY indicator. SECURITY indicator should illuminate for about 5 seconds and go out (BCM is programmed). If SECURITY indicator flashes one flash per second and engine starts, check wiring, contacts to key resistance pellet, and key for defects or intermittents. Repair or replace as necessary. Repeat procedure because module did not program key code.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.