2001 Chevrolet Venture Base, Van Cargo ExtendedFACTORY OEM SERVICE PROCEDURE

30-Minute Learn Procedure

NOTE: Ensure the latest Techline® Service Programming System (SPS) software is used.
  1. Using PassKey III® master key, turn ignition on, with engine off.
  2. Observe SECURITY indicator light for about 10 minutes. Indicator light should turn off.
  3. Turn ignition off and wait 5 seconds.
  4. Repeat steps  1 -  4 two more times for a total of 3 cycles or 30 minutes.
    5. NOTE: Vehicle learns key transponder information and/or password on the next ignition switch transition from OFF to CRANK position. Ignition must be turned off before attempting to start vehicle.
  5. Using PassKey III® master key, start vehicle. Vehicle has now learned the key transponder information and PCM has now learned the fuel continue password.
  6. Using scan tool, clear any DTCs.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.