Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001SILVERADO 1500 HD, RWDREPAIR AND DIAGNOSISGENERAL INFORMATIONCOMPUTER RELEARN PROCEDURESGENERAL MOTORS (CARS)CAMARO & FIREBIRDELECTRONICALLY ERASABLE PROGRAMMABLE READ ONLY MEMORY (EEPROM) PROGRAMMING
2001 Chevrolet Silverado 1500 HD, RWD
Electronically Erasable Programmable Read Only Memory (EEPROM) Programming
2001 Chevrolet Silverado 1500 HD, RWDSECTION Electronically Erasable Programmable Read Only Memory (EEPROM) Programming
- If Powertrain Control Module (PCM) was replaced, the EEPROM in the PCM must be programmed. If EEPROM is not programmed, a Diagnostic Trouble Code (DTC) will be set in the PCM.
- Ensure battery is fully charged. Ensure cable is properly connected on Data Link Connector (DLC). Turn ignition switch to ON position. Perform EEPROM programming using the Techline equipment manufacturer's instructions and latest software applicable for the vehicle model.
- On 3.8L, once EEPROM is reprogrammed, perform powertrain On-Board Diagnostic (OBD) system check. See POWERTRAIN ON-BOARD DIAGNOSTIC (OBD) SYSTEM CHECK in appropriate SELF-DIAGNOSTICS article in ENGINE PERFORMANCE. Ensure engine is idling for one minute before checking for DTCs when performing powertrain OBD system check. Perform Crankshaft Position (CKP) sensor variation learn procedure. See CRANKSHAFT POSITION (CKP) SENSOR VARIATION LEARN PROCEDURE (3.8L) .NOTE: If EEPROM programming fails, ensure all electrical connections on PCM are okay. Check Techline for latest software. If EEPROM programming still fails, replace PCM.
- On 5.7L, once EEPROM is reprogrammed, perform powertrain On-Board Diagnostic (OBD) system check. See POWERTRAIN ON-BOARD DIAGNOSTIC (OBD) SYSTEM CHECK in appropriate SELF-DIAGNOSTICS article in ENGINE PERFORMANCE. Ensure engine is idling for one minute before checking for DTCs when performing powertrain OBD system check. Also, after EEPROM is reprogrammed, the idle learn procedure and then Crankshaft Position (CKP) sensor variation learn procedure must be performed using proper procedures. See IDLE LEARN PROCEDURE (5.7L) . See CRANKSHAFT POSITION (CKP) SENSOR VARIATION LEARN PROCEDURE (5.7L) .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.