Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Chevrolet Prizm Base, StandardFACTORY OEM SERVICE PROCEDURE
Engine Controls Self-Diagnostics - 1.8L
- Introduction
- Self-Diagnostic System
- Programming
- Inspection/Maintenance Procedures
- Drive Cycles
- Inspection/Maintenance System Check
- Inspection/Maintenance Complete System Set Procedure
- Inspection/Maintenance System DTC Table
- Inspection/Maintenance Catalyst System Set Procedure
- Inspection/Maintenance EVAP System Set Procedure
- Inspection/Maintenance Heated Oxygen Sensor/Oxygen Sensor (Ho2S/O2S) System Set Procedure
- Inspection/Maintenance Heated Oxygen Sensor (Ho2S) System Set Procedure
- Summary
- Diagnostic Trouble Code Definitions
- System Tests
- Diagnostic Tests
- Notes
- DTC P0100: MAF Sensor Circuit
- DTC P0101: MAF Sensor Performance
- DTC P0110: IAT Sensor Circuit
- DTC P0115: ECT Sensor Circuit
- DTC P0116: ECT Sensor Circuit Performance
- DTC P0120: Throttle Position Sensor Circuit
- DTC P0121: Throttle Position Sensor System Performance
- DTC P0125: ECT Excessive Time To Enter Closed Loop
- DTC P0128: ECT Less Than Thermostat Regulating Temperature
- DTC P0130: Ho2S Circuit - Sensor 1
- DTC P0133: Ho2S Slow Response - Bank 1, Sensor 1
- DTC P0135: Ho2S Heater Performance - Sensor 1
- DTC P0136: Ho2S Circuit - Sensor 2
- DTC P0141: Ho2S Heater Performance - Sensor 2
- DTC P0171: Fuel Trim System - Lean
- DTC P0172: Fuel Trim System - Rich
- DTC P0300: Engine Misfire Detected
- DTC P0301: Cylinder No. 1 Misfire Detected
- DTC P0302: Cylinder No. 2 Misfire Detected
- DTC P0303: Cylinder No. 3 Misfire Detected
- DTC P0304: Cylinder No. 4 Misfire Detected
- DTC P0325: Knock Sensor Circuit
- DTC P0335: Crankshaft Position Sensor Circuit
- DTC P0340: Camshaft Position Sensor Circuit
- DTC P0420: Catalyst System Low Efficiency
- DTC P0440: Evaporative Emission System
- DTC P0441: Evaporative Emission System No Flow During Purge
- DTC P0442: Evaporative Emission System Leak Detected
- DTC P0446: Evaporative Emission System Vent Performance
- DTC P0450: Fuel Tank Pressure Sensor Circuit
- DTC P0451: Fuel Tank Pressure Sensor Performance
- DTC P0505: Idle Control System
- DTC P1300: Ignition Coil No. 1 Primary Feedback Circuit
- DTC P1305: Ignition Coil No. 2 Primary Feedback Circuit
- DTC P1310: Ignition Coil No. 3 Primary Feedback Circuit
- DTC P1315: Ignition Coil No. 4 Primary Feedback Circuit
- DTC P1335: Crankshaft Position Sensor Circuit
- DTC P1346: Intake Camshaft Position System Performance
- DTC P1349: Intake Camshaft Position System
- DTC P1600: Control Module Long Term Memory Reset
- DTC P1656: Intake Camshaft Position Actuator Solenoid Control
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.