Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Chevrolet MetroFACTORY OEM SERVICE PROCEDURE
Shift Interlock Cable
- Remove 6 screws retaining center console. Remove center console and rear console. Remove shift indicator cover if necessary. Loosen, but DO NOT remove shift interlock cable bolt. See Fig 1 . Ensure gearshift lever is in PARK position. While holding gearshift lever button in, rotate key release plate and insert a small screwdriver through key release plate to hold plate in position.
- Allow retaining spring to position shift interlock cable into correct position in bracket. Tighten shift interlock cable bolt to 115 INCH lbs. (13 N.m). Recheck operation prior to center console reassembly. Ensure key cannot be removed from ignition switch when gearshift lever is in any position except PARK position, and that gearshift lever cannot be moved from PARK position with ignition switch in LOCK position.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.