Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Chevrolet MetroFACTORY OEM SERVICE PROCEDURE
STOPLAMP Switch
- Disconnect the stoplamp switch electrical connector. Press the brake pedal. Loosen the locknut from the stoplamp switch (4). See Fig 1 .
- Use the following procedure to adjust the stoplamp switch (4):
- Pull the brake pedal all the way back and hold.
- Adjust the switch position so that the switch plunger is pressed by the brake pedal contact plate. Ensure that the threaded portion (2) of the switch (4) is within 0.06-0.08" (1.5-2.0 mm) from the pedal contact plate. See Fig 1 .
- Press the brake pedal and install the stoplamp switch locknut. Tighten the stoplamp switch locknut to 71 INCH lbs. (8 N.m). Connect the stoplamp switch electrical connector.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.