Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Chevrolet MetroFACTORY OEM SERVICE PROCEDURE
Code Enable Criteria
Conditions for running DTC:
- Engine speed is 1600-3000 RPM.
- Engine coolant temperature is 158-230°F (70-110°C).
- Intake air temperature is 14-158°F (-10 to 70°C).
- Fuel level is greater than 25 percent.
- Barometric pressure is greater than 11 psi (75 kPa).
- MAP change less is than 1.9 psi (13 kPa) per 16 firing events.
Conditions for setting DTC:
- Difference between expected TP sensor and actual input is greater than 20 degrees.
- Conditions are present for at least 3 seconds.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
