Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Chevrolet MetroFACTORY OEM SERVICE PROCEDURE
Fuel System Pressure: Prizm
- Relieve fuel system pressure. See FUEL SYSTEM PRESSURE RELEASE . Place shop towel around fuel feed hose, and remove quick connect coupling cover of fuel feed hose from fuel feed pipe at fuel rail. Using Fuel Line Quick Connect Separator (J-43178), disconnect quick connect coupling of fuel feed hose from fuel feed pipe. Separate fuel feed hose from fuel feed pipe.
- Install Fuel Rail Adapter (J-42982) between fuel feed pipe and fuel feed hose. Connect Fuel Pressure Gauge (J-34730-1A) to adapter. Ensure fuel tank has adequate supply of fuel. Connect negative battery cable. Start engine and warm to operating temperature. Check fuel pressure. See FUEL PRESSURE SPECIFICATIONS table. If fuel pressure is not within specification, diagnose fuel system. See FUEL SYSTEM DIAGNOSIS .
FUEL PRESSURE SPECIFICATIONS
| Application | psi (kg/cm2 ) | |
|---|---|---|
| Metro | ||
| Engine At Idle | 28.5-34.0 (2.0-2.4) | |
| Ignition On (Engine Off) | 38.5-44.0 (2.7-3.1) | |
| One Minute After Ignition Off | 28.5 (2.0) Minimum | |
| Prizm | ||
| Engine At Idle | 44.0-50.0 (3.1-3.5) | |
| Ignition On (Engine Off) | 44.0-50.0 (3.1-3.5) | |
| 5 Minutes After Ignition Off | 21.0 (1.5) Minimum | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.