Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Chevrolet MetroFACTORY OEM SERVICE PROCEDURE
Fuel System Pressure Release: Prizm
- Loosen fuel filler cap to relieve pressure in fuel tank. Remove circuit opening relay. Circuit opening relay is located under left side of instrument panel, above kick panel.
- Crank engine. Allow engine to start, then stall. After engine stalls, crank engine for an additional 3 seconds to relieve any remaining fuel pressure. Disconnect negative battery cable. Place shop towel around component to be serviced to reduce chance of personal injury.
- After repair of fuel-related component, connect negative battery cable. Install circuit opening relay and tighten fuel filler cap.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.