Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Chevrolet MetroFACTORY OEM SERVICE PROCEDURE
Component Locations
COMPONENT LOCATIONS
| Component | Location |
|---|---|
| Clutch Pedal Position Switch (M/T) | Mounted On Bracket Above Clutch Pedal |
| Instrument Panel Junction Block | Below Left Side Of Instrument Panel |
| Park/Neutral Position Switch (A/T) | Left Side Of Engine Compartment, Mounted To Top Of Transaxle |
| Powertrain Control Module | Behind Right Side Of Instrument Panel, Near Glove Box |
| Underhood Fuse Box | Left Side Of Engine Compartment, Near Battery |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.