2001 Chevrolet MetroFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Miscellaneous

MISCELLANEOUS LOCATION

Component Location
Anti-Lock Brake System (ABS) Motor Pack Assembly Left rear of engine compartment, attached to brake master cylinder. See Figure .
Blower Motor Resistor In blower housing assembly.
Data Link Connector (DLC) OBD II Under left side of dash, by center console.
Distributor (1.0L VIN 6) Top rear of engine. See Figure .
Duty Check Data Link Connector (DLC) Behind right side of dash. See Figure .
Early Fuel Evaporation (EFE) Heater (1.0L VIN 6) Mounted between intake manifold & throttle body.
Fuel Injector Resistor (1.0L VIN 6) On left side of firewall. See Figure .
Ignition Coil (1.0L VIN 6) On left side of firewall. See Figure .
Ignition Coil No. 1 (1.3L VIN 2) On cylinder head, over spark plug No. 4. See Figure .
Ignition Coil No. 2 (1.3L VIN 2) On cylinder head, over spark plug No. 2.
Noise Suppressor Filter (1.0L VIN 6) On left side of firewall. See Figure .
Supplemental Inflatable Restraint Data Link Connector (SIR DLC) Behind left side of dash, near junction block.
Chapter Navigation
Return to Chapter: Electrical Component Locator
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.