Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Chevrolet MetroFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Connectors
CONNECTORS LOCATION
| Component | Location |
|---|---|
| C112 (Black, 16 Pin) | Main harness to engine harness, on right rear side of engine compartment, near firewall. |
| C113 (Black, 16 Pin) | Main harness to engine harness, on right rear side of engine compartment, near firewall. |
| C200 (Natural, 12 Pin) | Main harness to I/P harness, behind left of dash, near junction block. |
| C204 (2 Pin) | Main harness to clutch pedal position switch, behind left side of dash. |
| C207 (Gray, 3 Pin) | I/P harness to dome lamp harness, on right side of upper dash. |
| C208 (Blue, 8 Pin) | Main harness to I/P harness, behind left of dash, near junction block. |
| C210 (Yellow, 5 Pin) | Supplemental inflatable restraint harness to I/P harness, behind left side of dash, near junction block. |
| C211 (6 Pin) | I/P harness to selector switch jumper for blower speed, behind center of dash. |
| C212 (Natural, 6 Pin) | Floor harness to left front door, behind left kick panel. |
| C213 (Natural, 6 Pin) | Floor harness to right front door, behind right kick panel. |
| C300 (White, 2 Pin) | Floor harness to fuel tank jumper harness, under rear passenger's seat. |
| C311 (White, 3 Pin) | Floor harness to fuel tank jumper harness, under rear passenger's seat. |
| C400 (Natural, 10 Pin) | Floor harness to luggage compartment harness, on left front side of luggage compartment, near left rear speaker. |
| C402 (6 Pin) | Floor harness to liftgate harness, at right rear corner of vehicle. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
