2001 Chevrolet MetroFACTORY OEM SERVICE PROCEDURE

Test A: Charging System Test

  1. Check generator mounting. Check wiring harness electrical connections at generator. Check battery cables. Check drive belt tension. See BELT TENSIONΒ  under ADJUSTMENTS. Ensure battery is fully charged. If problem exists, repair as necessary and then go to next step.
  2. Turn ignition switch to RUN position. If charge indicator light illuminates, go to next step. If charge indicator light does not illuminate, go to TEST C: CHARGE INDICATOR LIGHT INOPERATIVEΒ  .
  3. Start engine. If charge indicator lights turns off, system is okay. If charge indicator light stays illuminated, go to TEST B: CHARGE INDICATOR LIGHT ALWAYS ONΒ  .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.