2001 Chevrolet MetroFACTORY OEM SERVICE PROCEDURE

Output Devices

Output components are diagnosed for proper response to PCM commands. Components where functional monitoring is not feasible are monitored for circuit continuity and out-of-range values if applicable. Monitored components include, but are not limited to the following:

  • A/C relay.
  • Cooling fan relay.
  • Electronic transaxle controls.
  • EVAP canister purge valve.
  • Idle Speed Control (ISC) motor.
  • Malfunction Indicator Light (MIL) control.
  • Vehicle Speed Sensor (VSS) output.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.