Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Chevrolet Impala LSFACTORY OEM SERVICE PROCEDURE
Test C: Left Front Power Window Inoperative
- Review information in DESCRIPTION & OPERATION . Go to next step.
- Attempt to operate left front power window. If left front power window is inoperative, go to next step. If left front power window operates, perform appropriate test. See SYMPTOM INDEX table.
- Disconnect left front power window motor harness connector. It may be necessary to remove door trim panel for access to power window motor harness connector. See DOOR TRIM PANEL under REMOVAL & INSTALLATION. Connect a test light between ground and left front power window motor harness connector Dark Blue wire terminal. Operate left front power window motor to up position. If test light illuminates, go to next step. If test light does not illuminate, go to step 5 .
- Connect a test light between left front power window motor harness connector Dark Blue wire and Brown wire terminals. Operate left front power window motor to down position. If test light illuminates, go to step 7 . If test light does not illuminate, go to step 6 .
- Check for open in Dark Blue wire between left front power window motor and master window switch. See WIRING DIAGRAMS . Repair as necessary. After repair, go to step 11 . If no problem is found, go to step 8 .
- Check for open in Brown wire between left front power window motor and master window switch. See WIRING DIAGRAMS . Repair as necessary. After repair, go to step 11 . If no problem is found, go to step 8 .
- Check for poor connections at left front power window motor harness connector. Repair as necessary. After repair, go to step 11 . If no problem is found, go to step 9 .
- Check for poor connections at master switch assembly harness connector. Repair as necessary. After repair, go to step 11 . If no problem is found, go to step 10 .
- Replace left front window motor. See WINDOW MOTOR under REMOVAL & INSTALLATION. After repair, go to step 11 .
- Replace master switch assembly. See WINDOW SWITCH under REMOVAL & INSTALLATION. After repair, go to step 11 .
- Operate system to verify repairs. If system does not operate properly, go to step 2 . If system operates properly, system is okay.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
