Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Chevrolet Corvette Base, 2D Convertible, AutomaticFACTORY OEM SERVICE PROCEDURE
Steering Column Switch DTCS
STEERING COLUMN SWITCH DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description |
|---|---|
| DTC B2527 | HORN RELAY CIRCUIT LOW |
| DTC B2528 | HORN RELAY CIRCUIT HIGH |
| DTC B2587 | COLUMN LOCK/UNLOCK DRIVE "A" |
| DTC B2588 | COLUMN LOCK/UNLOCK DRIVE "A" |
| DTC B2592 | COLUMN LOCK/UNLOCK DRIVE "B" |
| DTC B2593 | COLUMN LOCK/UNLOCK DRIVE "B" |
| DTC B2852 | TELESCOPING COLUMN IN SWITCH SHORTED TO GROUND |
| DTC B2857 | TELESCOPING COLUMN OUT SWITCH SHORTED TO GROUND |
| DTC B2860 | STEERING COLUMN POSITION SENSOR OUT OF RANGE |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
