2001 Chevrolet Corvette Base, 2D Convertible, AutomaticFACTORY OEM SERVICE PROCEDURE

Torque Specifications

TORQUE SPECIFICATIONS

Application Ft. Lbs. (N.m)
Exhaust Manifold Nuts 15 (20)
Exhaust Muffler Bolts 37 (50)
Exhaust Pipe Brace Bolts 37 (50)
Exhaust Pipe Hanger Bolts 37 (50)
Negative Battery Cable-To-Battery Bolt 11 (15)
Oxygen Sensors 30 (41)
Positive Battery Cable-To-Starter Motor Stud Nut 11 (15)
Starter Mounting Bolts 37 (50)
INCH Lbs. (N.m)Β 
Positive Battery Cable-To-Solenoid Nut 89 (10)
Solenoid "S" Terminal Nut 35 (4)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.