Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Chevrolet Venture V6-3.4L VIN EFACTORY OEM SERVICE PROCEDURE
Body Control Module: Service and Repair
REMOVAL PROCEDURE
1. Disconnect the battery negative cable.
2. Remove the left side instrument panel insulator.
3. Push the release tab on the bottom of the bracket to release the body control module.
4. Slide the body control module from the bracket.
5. Disconnect the electrical connector.
INSTALLATION PROCEDURE
1. Connect the electrical to the body control module.
2. Align the tabs on the body control module with the slots in the mounting bracket. Push the body control module up until it clicks in place.
3. Install the left side instrument panel insulator.
4. Connect the battery negative cable.
5. Setup the BCMs customized options.
1. Disconnect the battery negative cable.
2. Remove the left side instrument panel insulator.
3. Push the release tab on the bottom of the bracket to release the body control module.
4. Slide the body control module from the bracket.
5. Disconnect the electrical connector.
INSTALLATION PROCEDURE
1. Connect the electrical to the body control module.
2. Align the tabs on the body control module with the slots in the mounting bracket. Push the body control module up until it clicks in place.
3. Install the left side instrument panel insulator.
4. Connect the battery negative cable.
5. Setup the BCMs customized options.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.