Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2000 Chevrolet Venture PlusFACTORY OEM SERVICE PROCEDURE

Removal Procedure

WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.

Important: The cruise control module is mounted to the left strut tower. Service the cruise control module as a complete unit.

Remove the cruise control cable from the cruise control module. Refer to Cruise Control Cable Replacement (3. 1L) or Cruise Control Cable Replacement (3.8L) .
Disconnect the electrical connector from the cruise control module.

Fig 1: Removing Cruise Control Cable From Cruise Control Module

Courtesy of GENERAL MOTORS CORP.

Remove the cruise control module retaining nuts from the shock tower.

Fig 2: Removing Cruise Control Module From Shock Tower

Courtesy of GENERAL MOTORS CORP.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.