If ignition is turned off or driver's door is opened while Body Control Module (BCM) is in any customization mode, customization procedure will end and BCM will remain in most recent mode.
Remove BCM PRGRM fuse located in instrument panel fuse block. Close all vehicle doors and liftgate. Turn ignition switch to ACC position. Seat belt warning light flashes and chime sounds 1-4 times to indicate BCM is in feature customization mode.
Press transmitter LOCK button. Seat belt warning light will flash and chime will sound 1-2 times to indicate which remote unlock control mode BCM is in. Each time transmitter LOCK button is pressed, mode number will advance. After mode 4, mode 1 will repeat.
See REMOTE ACTIVATION VERIFICATION CUSTOMIZATION table. To exit and save current customization, turn ignition off and replace BCM PRGRM fuse.

REMOTE ACTIVATION VERIFICATION CUSTOMIZATION

Mode

Remote UnlockVerification

Remote Lock Verification

Disabled

Park Lights Only

Horn & Park Lights

Park Lights Only

⁽¹⁾ Horn Only
⁽²⁾ Horn & Park Lights

⁽¹⁾	First press of transmitter LOCK button.

⁽²⁾	Second press of transmitter LOCK button.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Remote Activation Verification Customization