2000 Chevrolet Venture PlusFACTORY OEM SERVICE PROCEDURE

Last Door Closed Locking

  1. When a vehicle door is open, ignition switch in LOCK position and key removed from ignition switch, press power door lock switch or Remote Keyless Entry (RKE) transmitter to LOCK all doors. Exit vehicle and close all doors. When last door closed locking feature is enabled, BCM will automatically lock all doors about five seconds after all doors are closed. To enable last door closed locking feature, ensure locking control mode 3 or 4 is selected. See LOCKING CONTROL MODES  .
  2. To cancel last door closed locking command, press door lock switch or RKE transmitter (if equipped) to UNLOCK doors or turn ignition switch to ACC or RUN position.
  3. To override last door closed locking feature, press LOCK twice using power door lock switch or RKE transmitter (if equipped). BCM will lock all doors immediately, even with a door still open.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.