2000 Chevrolet Venture PlusFACTORY OEM SERVICE PROCEDURE

Pass-Key(R) III System Auto Learn Procedure

NOTE: PASS-Key(R) III system auto learn procedure must be performed if all keys are lost, or Powertrain Control Module (PCM), PASS-Key(R) III module, ignition lock cylinder, steering column assembly or ignition key are replaced. A password is communicated between PASS-Key(R) III module and PCM to provide engine operation. If PCM is replaced, the PCM must learn password from PASS-Key(R) III module.
  1. Insert a valid mechanical coded unlearned ignition key in ignition switch. Turn ignition switch to RUN position. SECURITY indicator light will flash once per second for 10 minutes for length of auto learn timer.
  2. When auto learn timer expires and SECURITY indicator light turns off, turn ignition switch to OFF position. Remove ignition key. Wait 10 seconds.
  3. Repeat steps  1 and  2 two more times. Insert newly learned ignition key in ignition switch.
  4. Turn ignition switch to RUN position. SECURITY indicator light should remain off to indicate ignition key was learned. This will be the only learned key. To program more keys, see PASS-KEY(R) III SYSTEM QUICK LEARN PROCEDURE  . If SECURITY indicator light does not remain off, repeat procedure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.