Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Chevrolet Tracker 4D Utility, RWD, AutomaticFACTORY OEM SERVICE PROCEDURE
Generator Specifications
GENERATOR SPECIFICATIONS
| Application | Specification | |
|---|---|---|
| Brush Length | ||
| Limit (Minimum) | .08" (2 mm) | |
| Standard | .63" (16 mm) | |
| Capacitor | 0.5 Microfarads | |
| Generated Regulator Output | 13.2-15.0 Volts | |
| Rotor Resistance | ||
| Between Rotor & Slip Rings | More Than 5 Ohms | |
| Between Slip Rings | 2.5-2.9 Ohms | |
| Stator Resistance | ||
| Between Stator Core & Stator Leads | More Than 5 Ohms | |
| Between Stator Leads | Less Than 5 Ohms | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.