Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Chevrolet Prizm Base, StandardFACTORY OEM SERVICE PROCEDURE
Engine Performance 1.8L DTCS
ENGINE PERFORMANCE 1.8L DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description |
|---|---|
| P0100 | MAP Sensor Circuit |
| P0101 | MAP Sensor Performance |
| P0110 | IAT Sensor Circuit |
| P0115 | ECT Sensor Circuit |
| P0116 | ECT Sensor Circuit Performance |
| P0120 | TP Sensor Circuit |
| P0121 | TP Sensor System Performance |
| P0125 | ECT Excessive Time To Enter Closed Loop |
| P0128 | ECT Less Than Thermostat Regulating Temperature |
| P0130 | HO2S Circuit - Sensor 1 |
| P0133 | HO2S Slow Response - Bank 1, Sensor 1 |
| P0135 | HO2S Heater Performance - Sensor 1 |
| P0136 | HO2S Circuit - Sensor 2 |
| P0141 | HO2S Heater Performance - Sensor 2 |
| P0171 | Fuel Trim System - Lean |
| P0172 | Fuel Trim System - Rich |
| P0300 | Engine Misfire Detected |
| P0301 | Cylinder No. 1 Misfire Detected |
| P0302 | Cylinder No. 2 Misfire Detected |
| P0303 | Cylinder No. 3 Misfire Detected |
| P0304 | Cylinder No. 4 Misfire Detected |
| P0325 | Knock Sensor (KS) Circuit |
| P0335 | Crankshaft Position (CKP) Sensor Circuit |
| P0340 | Camshaft Position (CMP) Sensor Circuit |
| P0420 | Catalyst System Low Efficiency |
| P0440 | Evaporative Emission (EVAP) System |
| P0441 | EVAP System No Flow During Purge |
| P0446 | EVAP Vent System Performance |
| P0450 | Fuel Tank Pressure Sensor Circuit |
| P0451 | Fuel Tank Pressure Sensor Performance |
| P0500 | Vehicle Speed Sensor (VSS) Circuit |
| P0505 | Idle Control System |
| P1300 | Ignition Coil No. 1 Primary Feedback Circuit |
| P1305 | Ignition Coil No. 2 Primary Feedback Circuit |
| P1310 | Ignition Coil No. 3 Primary Feedback Circuit |
| P1315 | Ignition Coil No. 4 Primary Feedback Circuit |
| P1335 | Crankshaft Position (CKP) Sensor Circuit |
| P1346 | Intake Camshaft Position (CMP) System Performance |
| P1349 | Intake Camshaft Position (CMP) System |
| P1520 | Stoplight Switch Circuit |
| P1600 | Control Module Long Term Memory Reset |
| P1656 | Intake Camshaft Position (CMP) Actuator Solenoid Control |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
