Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Dis (1.3L & 1.8L): Spark
Crank engine and check for spark at spark plug wires or ignition coil boots using Spark Tester (J-26792). If spark is present for only some cylinders, check for faulty ignition coil or spark plug wire. On 1.3L, spark plug high tension wire resistance should be 1200-3000 ohms per foot. For additional information, see appropriate diagnostic procedure under NO START DIAGNOSIS .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.