2000 Chevrolet Malibu BaseFACTORY OEM SERVICE PROCEDURE

Control Units

CONTROL UNITS

Component Component Location
Body Control Module (BCM) Below right side of dash, near blower motor. See Figure .
Brake Pressure Modulator Valve (BPMV) At lower left front of engine compartment.
Cruise Control Module On right side of engine compartment. See Figure .
Electronic Brake Control Module (EBCM) Inside left front fender.
Fuel Tank Module Under rear of vehicle, at fuel tank.
Ignition Control Module On top front of engine.
Inflatable Restraint Sensing & Diagnostic Module Under right front seat.
Lamp Dimmer Module On left side of dash.
Powertrain Control Module (PCM) Below left side of dash, near steering column. See Figure .
Remote Control Door Lock Receiver On rear package shelf.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.