Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Chevrolet Malibu BaseFACTORY OEM SERVICE PROCEDURE
Transmitter RESYNCHRONIZATION
NOTE:
Resynchronization works only if transmitter is programmed.
- Resynchronization of transmitter to receiver may be necessary if transmitter is weak, transmitter battery has been changed, vehicle battery is weak, vehicle battery has been changed, vehicle battery has been disconnected or transmitter has been activated more than 255 times outside range of receiver (30 ft.).
- To resynchronize transmitter, stand next to vehicle. Depress and hold LOCK and UNLOCK buttons at same time for 7 seconds. Receiver will acknowledge resynchronization of transmitter by chirping horn 3 times.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.