Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Chevrolet Malibu BaseFACTORY OEM SERVICE PROCEDURE
With Scan Tool
NOTE:
A Tech 2 scan tool is recommended for programming purposes. Consult scan tool manufacturer's owner's manual for other scan tools to determine compatibility and usage.
- Turn ignition off. Install scan tool to Data Link Connector (DLC) on left side of dash at bottom of instrument panel. Turn ignition on, engine off.
- Select body, model year and body style. Select "BODY CONTROL MODULE". Select "SPECIAL FUNCTIONS". Select "PROGRAM KEY FOBS". Follow instructions on scan tool to program transmitters.
- Operate transmitter functions to verify correct system operation.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.