Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Chevrolet LuminaFACTORY OEM SERVICE PROCEDURE
Remote Keyless Entry System Operation Check
- Turn instrument panel dimmer switch off. Remove key from ignition switch. Close all vehicle doors. Press LOCK button on RKE transmitter. All doors should lock and courtesy lights should illuminate for 2 seconds. If operation is as specified, go to next step. If operation is not as specified, diagnose by symptom. See SYSTEM TESTS .
- Press UNLOCK button on RKE transmitter. Courtesy lights should illuminate for 55 seconds and driver door will unlock. If operation is as specified, go to next step. If operation is not as specified, diagnose by symptom. See SYSTEM TESTS .
- Press UNLOCK button again within 5 seconds. Remaining doors should unlock. If operation is as specified, go to next step. If operation is not as specified, diagnose by symptom. See SYSTEM TESTS .
- Press trunk release button on RKE transmitter. Trunk lid should release. If operation is as specified, go to next step. If operation is not as specified, diagnose by symptom. See SYSTEM TESTS .
- Close trunk lid. Press firmly on brake pedal. Start engine and shift transaxle into drive. Press trunk release button. Trunk should not release. If operation is not as specified, see appropriate POWER REAR COMPARTMENT & FUEL DOOR RELEASE SYSTEMS article.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.