2000 Chevrolet LuminaFACTORY OEM SERVICE PROCEDURE

Component Locations

COMPONENT LOCATIONS

Component Location
Engine Wiring Harness Junction Block No. 1 Right Side Engine Compartment, Forward Of Strut Tower
Instrument Panel Fuse Block Right Side Of Instrument Panel, In Right Front Door Opening
Park/Neutral Position Switch Top Of Steering Column, Near Gear Selector
Power Door Lock Relay Behind Right Side Of Instrument Panel
Remote Control Door Lock Receiver Under Right Side Of Rear Window Trim
Remote Keyless Programming Connector In Right Side Of Trunk, Taped To Harness Near Antenna Mast
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.