Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Chevrolet Impala LSFACTORY OEM SERVICE PROCEDURE
PASSLOCK™ System
NOTE:
This procedure allows relearning of BCM or PCM learned data code after replacement of Passlock™ module, Passlock™ sensor or BCM. DTC B3031 will set when entering programming mode. Reprogram BCM with proper RPO configurations before performing 30-minute relearn procedure. After reprogramming a new PCM, PCM will learn incoming fuel continue password immediately. After initial password is learned, relearn procedure must be performed to change password.
- Clear all Diagnostic Trouble Codes (DTC). Refer to scan tool manufacturer's instructions. Turn ignition off. Replace component(s) as necessary.
- With transmission in Park (A/T) or Neutral (M/T), momentarily turn ignition switch to START position (DO NOT start engine). Leave ignition switch in RUN position (engine off). After 10 minutes, when SECURITY indicator light turns off, turn ignition switch to OFF position for 5 seconds.
- Repeat step 2 twice more. Turn ignition switch to OFF position. Auto learn procedure will be completed during next start attempt. Clear all DTCs.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
