Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Chevrolet Corvette 2D Convertible, AutomaticFACTORY OEM SERVICE PROCEDURE
Control Units
CONTROL UNITS
| Component | Component Location |
|---|---|
| Blower Motor Control Module | Behind right side of dash. See Figure . |
| Body Control Module (BCM) | Mounted on toe board, in right footwell. |
| Door Control Module (2) | In lower center of respective door. |
| Driver Seat Control Module | On underside of driver's seat. See Figure . |
| Electronic Brake/Traction Control Module (EBTCM) | At left front side of engine compartment, on frame rail. |
| Electronic Suspension Control (ESC) Module | In rear compartment, inside rear tub. See Figure . |
| Headlamp Opening Door Actuator Control Module | In lower right front of engine compartment. See Figure . |
| Ignition Control/Coil Module (8) | On valve covers, at top of respective cylinders. See Figure . |
| Inflatable Restraint Sensing & Diagnostic Module | Below center of dash. See Figure . |
| Powertrain Control Module (PCM) | On right side of engine compartment. See Figure . |
| Radio Antenna Module | Behind lower "B" pillar trim panel. |
| Remote Control Door Lock Receiver | On left side of rear compartment. |
| Throttle Actuator Control (TAC) Module | On PCM, below battery. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
