Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2000 Chevrolet Corvette 2D Convertible, AutomaticFACTORY OEM SERVICE PROCEDURE

Torque Specifications

TORQUE SPECIFICATIONS

Application

Ft. Lbs. (N.m)

Brakeline-To-BPMV

12 (16)

Brakeline-To-Combination Valve

13 (18)

EBTCM/BPMV Insulator

11 (15)

Lower Ball Joint Stud Nut

Initial Torque

15 (20)

Tighten An Additional

210 Degrees

Check Minimum Torque

52 (70)

Outer Tie Rod End Stud Nut

Initial Torque

15(20)

Tighten An Additional

160 Degrees

Check Minimum Torque

33 (45)

Rear Spindle Nut

118 (160)

Stabilizer Shaft Link Nuts

53 (72)

Tie Rod Jam Nut

44 (60)

Upper Ball Joint Stub Nuts

Initial Torque

15(20)

Tighten An Additional

250 Degrees

Check Minimum Torque

41 (55)

Wheel Hub/Speed Sensor-To-Steering Knuckle

96 (130)

Wheel Lug Nut

100 (136)

INCH Lbs. (N.m)

EBTCM/BPMV Mounting Nuts

89 (10)

EBTCM-To-BPMV Bolt

⁽¹⁾

Lateral Accelerometer Nuts

27 (3)

⁽¹⁾	Tighten to 27 INCH lbs. (3 N.m), then to 53 INCH lbs. (6 N.m).

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.