2000 Chevrolet Camaro SS, 2D Coupe, AutomaticFACTORY OEM SERVICE PROCEDURE

Programming New Module

NOTE: New modules are unprogrammed. New module must be programmed with code that matches customer's key for PASS-Key(R) II operation. New module can only be programmed once.
  1. To program a NEW Body Control Module (BCM), install new module into vehicle. Insert customer's key into ignition switch and turn to RUN position. Start engine to verify operation.
  2. Observe SECURITY indicator light. SECURITY indicator light should illuminate for about 5 seconds and go out (BCM is programmed). If SECURITY indicator light flashes one flash per second and engine starts, module did not program key code. Check wiring, contacts to key resistance pellet and key for defects or intermittents. Repair or replace as necessary, and then repeat programming procedure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.