2000 Chevrolet Blazer 4D Utility, RWDFACTORY OEM SERVICE PROCEDURE

Scan Tool Inoperative

  1. Check for battery voltage at DLC terminal No. 16 (Orange wire). If battery voltage exists, go to next step. If battery voltage does not exist, repair open, blown fuse or short to ground as necessary. After repair, go to BODY CONTROL MODULE (BCM) DIAGNOSTIC SYSTEM CHECKΒ  .
  2. Check for open circuit between DLC terminal No. 4 (Black/White wire) and ground. If no problem is found, go to next step. If problem is found, repair open or high resistance between DLC and ground. After repair, go to BODY CONTROL MODULE (BCM) DIAGNOSTIC SYSTEM CHECKΒ  .
  3. Check for damage and poor connections on DLC terminals No. 4 and No. 16. If no problem is found, go to next step. If problem is found, repair as necessary. After repair, go to BODY CONTROL MODULE (BCM) DIAGNOSTIC SYSTEM CHECKΒ  .
  4. Check scan tool. Follow scan tool manufacturer's instructions. After repair, go to BODY CONTROL MODULE (BCM) DIAGNOSTIC SYSTEM CHECKΒ  .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.