2000 Chevrolet Blazer 4D Utility, RWDFACTORY OEM SERVICE PROCEDURE

Component Locations

COMPONENT LOCATIONS

Component Location
Ambient Light Sensor Top Of Instrument Panel, In Speaker Grille
Body Control Module (BCM) Below Right Side Of Instrument Panel
Door Ajar Switch In Respective Door
Electronic Brake Control Module (EBCM) Inside Left Fender
Engine Coolant Level Switch Right Front Corner Of Engine Compartment, Attached To Coolant Reservoir
Fuel Tank Module Under Center Rear Of Vehicle
Ignition Switch In Steering Column
Body Relay Block Under Left End Of Instrument Panel
Instrument Panel Fuse Block Under Left End Of Instrument Panel
Parking Brake Switch Connector Under Left Kick Panel
Powertrain Control Module (PCM) Right Side Of Engine Compartment
Seat Belt Switch Under Driver's Seat
Sensing & Diagnostic Module (SDM) Under Passenger's Seat
Underhood Junction Block Left Side Of Engine Compartment
Washer Fluid Level Sensor Inside Left Fender
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.