Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1999 Chevrolet Venture Base, Van Cargo ExtendedFACTORY OEM SERVICE PROCEDURE
External Pages
These are pages that do not belong to the exact selected vehicle (1999 Chevrolet Venture Base, Van Cargo Extended), but are still accessible from a link in your vehicle's manual. Be very cautious using repair info from here because these pages may not apply to your vehicle.
- Different car
- Section 1 (Manual Transmission Clutches)
- Section 2 (Disc Brakes & Drum Brakes)
- Section 3 (Anti-Lock Brake System)
- Section 4 (Engine Mechanical - 4.3L V6, 5.0L, 5.7L & 7.4L V8 - VINS [W,X,M,R,J])
- Section 5 (Power Brake Booster - Hydro-Boost)
- Section 6 (Body Control Module)
- Section 7 (Computer Relearn Procedures)
- Section 8 (Computer Relearn Procedures)
- Section 9 (Engine Control System - Tests W/Codes)
- Section 10 (Supplemental Inflatable Restraint System)
- Section 11 (Instrument Panel Displays & Instrument Panel Gages)
- Section 12 (Charging System)
- Section 13 (Engine Control System - Removal, Installation & Overhaul)
- Section 14 (Supplemental Inflatable Restraint System Deactivation Procedures)
- Section 15 (Computer Relearn Procedures)
- Section 16 (Instrument Panel - Analog)
- Section 17 (Engine Controls - Service & Adjustment Specifications)
- Section 18 (Automatic Transaxle Servicing)
- Section 19 (System Wiring Diagrams)
- Section 20 (System Wiring Diagrams)
- Section 21 (System Wiring Diagrams)
- Section 22 (Engine Controls - Removal & Installation)
- Section 23 (Vacuum Diagrams)
- Section 24 (Engine Controls - Self-Diagnostics)
- Section 25 (Engine Controls - Basic Diagnostic Procedures)
- Section 26 (Engine Controls - System & Component Testing)
- Section 27 (Engine Controls - Troubleshooting - No Codes)
- Section 28 (Engine Control System - Sensor Range Charts)
- Section 29 (Disc Brakes - Rear - S & T Series)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.