Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1999 Chevrolet Forward Control P12FACTORY OEM SERVICE PROCEDURE
Torque Specifications
WARNING: This page is about a different variant/trim than selected.
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |
|---|---|---|
| A/C Compressor Mounting Nut | 18 (25) | |
| A/C Compressor Bracket Bolt | ||
| 7.4L | 37 (50) | |
| All Other Models | 24 (33) | |
| Tube Fittings | ||
| Condenser-To-Accumulator | 11 (15) | |
| Evaporator | 13 (17) | |
| Evaporator-To-Accumulator | 13 (17) | |
| Refrigerant Hoses | ||
| Condenser | 17 (23) | |
| Evaporator | 24 (32) | |
| Compressor | 26 (35) | |
| INCH Lbs. (N.m)Β | ||
| Accumulator Mounting Bolt | 25 (2.7) | |
| Condenser Mounting Bolt | ||
| Motor Home | 53 (6) | |
| Commercial Chassis | 156 (33) | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
