Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1999 Chevrolet Forward Control P12FACTORY OEM SERVICE PROCEDURE
A/C System Performance
WARNING: This page is about a different variant/trim than selected.
- Park vehicle in shaded area. Ventilate interior. Vent exhaust. Install manifold gauge set. Measure and record ambient temperature and relative humidity. Close doors and windows. Set mode control to normal A/C. Operate blower control at high speed, and set temperature control to full cold position. Insert thermometer into right center outlet.
- Set shift lever to Park or Neutral position. Run engine at 2000 RPM until outlet air reaches lowest temperature. Record outlet temperature, and high-side and low-side pressures. Turn engine off. Compare readings with specifications. See A/C PERFORMANCE SPECIFICATIONS table.
A/C PERFORMANCE SPECIFICATIONS
| Ambient Temp. °F (°C) (1) | (2)Low-Side Pressure psi (kg/cm2 ) | (2)High-Side Pressure psi (kg/cm2 ) | (3)Outlet Temp. °F (°C) | ||||||
|---|---|---|---|---|---|---|---|---|---|
| 70 (21) | 32 (2.2) | 240 (16.9) | 50 (10) | ||||||
| 80 (27) | 37 (2.6) | 290 (20.4) | 56 (13) | ||||||
| 90 (32) | 44 (3.1) | 340 (23.9) | 63 (17) | ||||||
| 100 (38) | 55 (3.9) | 395 (27.8) | 75 (24) | ||||||
|
|||||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
