Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1999 Chevrolet Forward Control P12FACTORY OEM SERVICE PROCEDURE
Section 3 (HVAC System): Specifications
WARNING: This page is about a different variant/trim than selected.
SPECIFICATIONS
| Application | Specification | |||||||
|---|---|---|---|---|---|---|---|---|
| Compressor Type | Harrison HR6-HE 6-Cyl. Or Seltec TM-16 HD |
|||||||
| Compressor Belt Tension | (1) | |||||||
| System Oil Capacity | (2) 9.0 ozs. | |||||||
| Refrigerant (R-134a) Capacity | 48 ozs. | |||||||
| System Operating Pressures (3) | ||||||||
| High Side | 199-255 psi (14-18 kg/cm2 ) | |||||||
| Low Side | 18-38 psi (1.2-2.6 kg/cm2 ) | |||||||
|
||||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
