1999 Chevrolet Forward Control P12FACTORY OEM SERVICE PROCEDURE

Section 3 (HVAC System): Description

WARNING: This page is about a different variant/trim than selected.

Temperature control and mode selector lever control various A/C-heating modes. Blower switch selects any of 4 blower speeds. In A/C mode, a pressure switch on low pressure side cycles the compressor clutch to maintain a constant discharge air temperature. The heater system blends heated outside air with cooler outside air to obtain desired temperature. Various sensors control compressor and cooling fan operation.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.