1999 Chevrolet Cutaway 7.4 JFACTORY OEM SERVICE PROCEDURE

Transmitter Programming

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2002 GMC Savana, 2002 Chevrolet Chevy Express, 2001 GMC Savana Special, 2001 GMC Savana Camper Special, and 2001 GMC Savana. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ground terminal No. 4 (Black wire) to terminal No. 8 (Black/White wire) of Data Link Connector (DLC). Press LOCK and UNLOCK buttons simultaneously on first transmitter to be programmed until locks cycle, about 10 seconds. Receiver will respond by locking/unlocking all doors.
  2. Press any button on next transmitter to be programmed within one minute. Receiver will again respond by locking/unlocking all doors.
  3. Repeat step Β 2 for each additional transmitter, up to 4. Remove ground jumper from DLC terminals No. 4 and 8. Transmitter operation can be verified by locking and unlocking doors.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.