Includes: Replace Rings, Main and Rod Bearings, Camshaft(s), Crankshaft and Timing Components. Remove Cylinder ridge, burnish Cylinders, grind Valves and clean and test or replace Lifters. Includes (where applicable): Adjust Valves. DOES NOT include Pin fit or rebore and align Rods. See machine operations.

Applies To	Standard Hours	Skill Level
4WD,Automatic Trans	29.6	A
Additional Procedure: ENGINE ASSEMBLY: Remove, Install, and Overhaul:
w/Skid Plate add	0.3	A
Where Air Cond interferes add	0.3	A
Where Cruise Control interferes add	0.2	A
Where Eng Oil Cooler interferes add	0.4	A
Where Pwr Stg interferes add	0.4	A
Where Trans Oil Cooler interferes add	0.2	A
Combination Procedure: CAMSHAFT BEARING: Remove & Replace: NOTE: This operation applies to full circle, resistance fit bearings only. For split cap type bearings use Camshaft - R&R.
Each	0.3	A
Combination Procedure: OIL PUMP: Overhaul:
	0.6	B
Combination Procedure: VALVE GUIDE: Remove & Replace:
Each	0.2	A

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Engine Assembly: Remove, Install, and Overhaul

Use the Manual With the Right Hardware

When to See a Mechanic

Rather have a pro handle this?