Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1998 Chevrolet Venture Base, Van Cargo ExtendedFACTORY OEM SERVICE PROCEDURE
Component Locations
COMPONENT LOCATIONS
| Component | Location |
|---|---|
| Body Control Module (BCM) | Under Right Side Of Instrument Panel, Right Of Glove Box |
| Fuse Block | Right Side Of Instrument Panel, In Door Opening |
| Headlight & Instrument Panel Dimmer Switch | Left Of Instrument Cluster |
| Relay Center | Mounted With BCM, Near Right Rear Top Side Of Glove Box |
| Remote Control Door Lock Receiver (RCDLR) | Under Center Instrument Panel Trim, Near Windshield Defrost Vent |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.