Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1998 Chevrolet Tracker 4D Utility, RWDFACTORY OEM SERVICE PROCEDURE
Component Locations
COMPONENT LOCATIONS
| Component | Location | |
|---|---|---|
| Fuse Block No. 2 | Under Left Side Of Instrument Panel | |
| Junction Connectors No. 4 & 5 | Floor Harness, Under Rear Center Console | |
| Power Window/Door Lock Switch | In Left Front Door, In Armrest | |
| Power Window Motor | In Respective Door, Behind Trim Panel Near Armrest | |
| Power Window Switch | In Respective Door, In Or Near Armrest | |
| Remote Power Window Switch | ||
| Left Rear | Left Rear Of Center Console | |
| Right Rear | Right Rear Of Center Console | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.