Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1998 Chevrolet Tracker 4D Utility, 4WD, AutomaticFACTORY OEM SERVICE PROCEDURE
Mechanical Inspection: Compression
Check engine mechanical condition with a compression gauge, vacuum gauge, or an engine analyzer. See engine analyzer manual for specific instructions. For compression specifications, see COMPRESSION SPECIFICATIONS table.
COMPRESSION SPECIFICATIONS
| Application | Specification | |
|---|---|---|
| Compression Ratio | 9.5:1 | |
| Compression Pressure | ||
| Standard | 199 psi (14.0 kg/cm2 ) | |
| Limit | 170 psi (11.9 kg/cm2 ) | |
NOTE:
When performing exhaust system backpressure test, ensure transmission is in Neutral or Park. Accurate reading cannot be obtained unless vehicle remains in Neutral or Park.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.