1998 Chevrolet Tracker 2D Utility, RWD, AutomaticFACTORY OEM SERVICE PROCEDURE

Retrieving Codes

NOTE: OBD II vehicles have options available in the scan tool DTC mode to display enhanced information available. However, to fully utilize information and procedures requires the use of a Tech 1 or 2 scan tool. See scan tool operator's manual for additional information.

DTCs are retrieved using a Tech 1 or other OBD-II compatible scan tool connected to OBD-II 16-pin Data Link Connector (DLC). See Figure . DLC is located below instrument panel and is accessible from driver's side. Follow scan tool manufacturer's instructions when retrieving DTCs.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.